AC Heated Bed PCB Fully Assembled

Description

This MOD consists of a PCB and Mount to tidy up the cabling at the back of the heated bed. The mount can be mounted between the bed frame on top of the bottom frame extrusion and will not interfere with any of the purge buckets.
WARNING
You are connecting Mains wiring with high voltages to the PCB. You can die if you don't understand what you are doing. If you are not familiar with electronics, please ask a professional for assistance. I will not be accountable for any damages, injuries or fatalities.
That being said, the PCB was designed with the following specs:
Mains traces are 3.560mm wide. That is sufficiant for a max thermal increase of 10 degrees at an ambiant temperature of 70 degrees Celcius at 3A current.
Please make sure your current does not exceed 3A (I would actually advise to keep some safety margin and not exceed 2.7A. To obtain Amps you need both Watts and Volts: The formula is (W)/(V) =(A). For example, if you have a power of 600W running at 220V, the current is 600W / 220V = 2.7A. If you are using a more powerfull heater or if you're using 110V you need to make sure that you reduce the power of your heater. This can be done in the Klipper config in the [heater_bed] section. It is advised to reduce the power anyway to not warp your bed by heating it to quickly by applying to much power. On 110 Volts with a maximum of 2.7A that would mean a max power of 297W, that's not a lot so this Mod might not be the most useful for those of you on 110V.
Additional information can be found .